Power ON A1ll for the first time or after factory data reset
The power on vibration indicates that A1II is starting up. When the user presses the key to turn on A1II for the first time A1II will enter bonding mode and LED A will blink
continuously until connected. When A1II is connected bonding mode stops with a short vibration and a connected status animation is displayed.
Note: If there is a failure in bonding will A1II power off after 5 minutes.
LED C
LED B
LED A
600 ms
600 ms
500 ms
10.2
Power ON A1ll when already bonded
Pressing the key to turn on an already bonded A1II will generate a power on vibration and then connected status is displayed with white LEDs since A1II is not connected
yet. As soon as AHA succeeds to reconnect the connected status animation is displayed in cyan.