• This set can be assembled in the order shown below.
3-1.
ASSEMBLY FLOW
Note: Follow the assembly procedure in the numerical order given.
3-2.
HOUSING
2 Install the hanger onto
4 Fit claw on B part.
3 Put the housing
under A part.
housing
A part
SECTION 3
ASSEMBLY OF MECHANISM DECK
3-2. HOUSING
(Page 11)
3-3. ARM (SUCTION)
(Page 12)
3-4. LEVER (LDG-A)/(LDG-B)
(Page 12)
3-5. GEAR (LDG-FT)
(Page 13)
3-6. GUIDE (C)
(Page 13)
3-7. MOUNTING POSITION
OF CAPSTAN/REEL MOTOR (M901)
(Page 14)
5 Fit projection on C part.
two claws of the housing.
C part
B part
7 Hold the hanger by bending the claw.
1 Install the catch to the hanger.
hanger
8 Hold the hanger by
bending the claw.
XR-CA630X
6 Fit projection on D part.
D part
11