HP 10500 Series Configuration Manual page 41

[Sysname] irf-port 1/2
[Sysname-irf-port1/2] port group interface ten-gigabitethernet 1/3/0/1
[Sysname-irf-port1/2] quit
[Sysname] interface ten-gigabitethernet 1/3/0/1
[Sysname-Ten-GigabitEthernet1/3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet1/3/0/1] quit
# Save the running configuration to the startup configuration file.
[Sysname] quit
<Sysname> save
2. Configure IRF on Device B:
# Assign member ID 2 to Device B.
<Sysname> system-view
[Sysname] irf member 2
Info: Member ID change will take effect after the member reboots and operates in
IRF mode.
# Enable IRF mode.
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup.
Continue? [Y/N]:y
Do you want to convert the content of the next startup configuration file
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device B reboots to form a single-chassis IRF fabric.
# Bind Ten-GigabitEthernet 2/3/0/1 to IRF-port 2/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 2/3/0/1
[Sysname-Ten-GigabitEthernet2/3/0/1] shutdown
[Sysname-Ten-GigabitEthernet2/3/0/1] quit
[Sysname] irf-port 2/1
[Sysname-irf-port2/1] port group interface ten-gigabitethernet 2/3/0/1
[Sysname-irf-port2/1] quit
[Sysname] interface ten-gigabitethernet 2/3/0/1
[Sysname-Ten-GigabitEthernet2/3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet2/3/0/1] quit
# Save the running configuration to startup configuration file.
[Sysname] quit
<Sysname> save
3. Activate the configuration on IRF ports:
# Connect Device B to Device A as shown in
# Log in to Device A. (Details not shown.)
# Activate IRF port configuration on Device A.
Figure 14.
37