Nokia RoofTop R240 User Manual page 59

Nokia RoofTop™ Wireless Router Installation Guide
3.
Connect the multiwire connection to the D-Connector in the bottom
of the wireless router. Tighten the two screws on the connector and
slide the rubber sleeve over the connections to prevent the ingress of
water.
Attach multiwire connection and Ground wire
NOTE: Take care when tightening the D-Connector to the router. It is
easy to damage the router casing if the screws are overtightened.
4.
Using cable ties and/ or adhesive tape, secure the multiwire
connection and ground wire (where used) to the mast. Take care to
avoid placing strain on the connectors when securing the cables to the
mast. Use ties/ tape about every two feet down the length of the mast.
Always cover the cable ties with electrical tape to prevent excess
pressure on the D-connector should the cable tie fail.
To install the router
33