Connect The Ac-Input Power Supply Unit - Cisco SCE 1000 Quick Start Manual

Connect the AC-Input Power Supply Unit

Plug the AC-input power cable into the AC-input power receptacle on the AC-input power supply
Step 1
For AC-input power, we recommend powering the SCE 2000 platform from a 120 VAC, 15A receptacle U.S. (240 VAC,
10A international) at the power source.
Figure 13 Connecting the AC Power
BY PA SS
1
IN
PO W ER B
OK
IN
Plug the AC power supply cable into the AC power source.
Step 2
Step 3 Turn the on/off switch to the on position.
Look at the IN and OK LEDs on the power supply unit and the corresponding Power LED on the front panel. If the
Step 4
AC-input power supply unit is operating properly, these LEDs will be glowing green.
Ensure that the power supply is properly aligned and the installation screw is tightened.
Step 5
12
PO W ER A
OK