Siemens SIMATIC RF300 System Manual page 33

Rfid-systems simatic sensors
Hide thumbs Also See for SIMATIC RF300:
Table of Contents

Advertisement

Time constants K and t
The values for K and t
is built up from several different times:
The values shown in the table must be used when calculating the maximum quantity of user data in
static mode. They are applicable for both reading and writing in the FRAM area. For writing in the
EEPROM area (max. 20 bytes), the byte time t
Transmission rate [baud]
Independent
Independent
Write
Read
In dynamic mode, the values for K and t
communication time only includes the processing time between the reader and the transponder and
the internal system processing time of these components. The communication times between the
communication module and the reader do not have to be taken into account because the command
for reading or writing is already active when the transponder enters the transmission field of the
reader.
The values shown above must be used when calculating the maximum quantity of user data in
dynamic mode. They are applicable for both writing and reading.
SIMATIC RF300
System Manual, Release 04/2006, J31069 D0166-U001-A2-7618
byte
Transmission rate [baud]
19200
57600
115200
include the overall time that is required for communication in static mode. It
byte
Serial communication between communication module, reader and
Processing time between reader and transponder and their internal processing time.
4.1 Fundamentals of application planning
K [ms]
28
14
11
is approx. 11 ms.
Byte
Memory area
FRAM
EEPROM
are independent of the transmission speed. The
byte
RF300 system planning
t
[ms]
byte
0,85
0,38
0,28
K [ms]
t
byte
8,5
0,13
8,5
12,2
8,5
0,13
[ms]
4-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents