Additional Information; Precautions - Sony HT-NT3 Operating Instructions Manual

1
Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
More than 30 mm
5.2 mm
10 mm
2
Fasten the screws to two studs in
the wall.
The screws should protrude by
8 mm to 9 mm.
8 mm to
9 mm
3
Hang the Bar Speaker on the
screws.
Align the holes at the rear of the Bar
Speaker with the screws, then hang
the Bar Speaker on the two screws.

Precautions

4 mm
On safety



On power sources

726 mm


On heat buildup
Although the system heats up during
operation, this is not a malfunction. If
you continuously use this system at a
large volume, the cabinet temperature
of the top, side and bottom rises
considerably. To avoid burning yourself,
do not touch the cabinet.

Additional Information

Should any solid object or liquid fall
into the cabinet, unplug the system
and have it checked by qualified
personnel before operating it any
further.
Do not touch the AC power cord
(mains lead) with wet hands. Doing so
may cause an electric shock.
Do not climb on the Bar Speaker and
subwoofer, as you may fall down and
injure yourself, or system damage may
result.
Before operating the system, check
that the operating voltage is identical
to your local power supply. The
operating voltage is indicated on the
nameplate at the rear of the Bar
Speaker and subwoofer.
If you are not going to use the system
for a long time, be sure to disconnect
the system from the wall outlet. To
disconnect the AC power cord (mains
lead), grasp the plug itself; never pull
the cord.
AC power cord (mains lead) must be
changed only at a qualified service
shop.
37
GB