To remove the control box cover, refer to the installation
manual of the indoor unit.
Connect receiver unit cable B to CN13 on the PCB.
Route the receiver unit cable using the same method for
the remote controller cables as described in the installation
manual of the indoor unit.
Fasten the receiver unit medium binder (included with the standard
parts), which is used for clamping cables, on the insulating tube.
Fasten the EMI filter of receiver unit cable B to the surrounding
cables with the small binder (included with the standard parts)
so that it does not contact other electrical parts.
EXAMPLE : Compact Duct
1
2
CN13
Screw
Receiver unit
Screw
cable B
1 Remove the control box
1 Connect receiver unit
cover of indoor unit
cable B to CN13 on the
accordance with
PCB of indoor unit.
installation manual.
3
4
Receiver
unit cable B
Binder small
(ACCESSORIES)
Screw
Receiver
Binder medium
unit cable A
(ACCESSORIES)
Screw
1 Connect receiver unit
1 Reattach the control
cable A to receiver unit
box cover.
cable B.
EXAMPLE : Slim Duct
Receiver unit terminal
1
Use 7 pins for receiver unit
Core
(CN18)
cable. (Receiver unit cable D)
Clamp
Controller
2
At first, connect the receiver
PCB
unit cable to the controller PCB.
Attach the core that comes
3
between controller PCB and
the clamp.
Use conduit hole when exter-
4
nal output cable is used.
If the wiring length is 10 m, replace with receiver
unit cable C (optional parts).
Receiver unit cable A (5m)
Bundle and fasten
the excess wiring.
Indoor unit
MAX. 10 m
Ceiling
Connect the cables, and then use heat shrink tubing
to protect the connection from dust and water droplets.
EXAMPLE
After shrinking
both ends of the
heat shrink
tubing, seal the
CONNECT
Heat shrink
ends with elec-
tubing
trical tape.
(ø25 L130)
Provide a trap in the receiver
unit wiring.
(To prevent water droplets
Receiver
from entering the receiver unit)
unit