Service Programmes - Siemens TK76K573 Instruction Manual

de en
N.B.: After cleaning thoroughly, the seals of
the brewing unit should be greased
regularly for optimal care. Apply a thin layer
of the special grease intended for this
purpose (Order No. 311368) all around the
seals.

Service programmes

At certain intervals, depending on how the
appliance is used, the display will show one
of the following texts instead of the coffee
selection:

Service - change filter
!
– ▸
i - button 3 sec.

Service - clean
!
– ▸
i - button 3 sec.

Service - descale
!
– ▸
i - button 3 sec.

Service - Calc'n'Clean
!
– ▸
i - button 3 sec.
Then the water filter should be changed
immediately or the appliance cleaned or
descaled using the corresponding
programme (described on the next pages).
Otherwise the appliance may be damaged.
46
The service programmes can also
be started manually in the settings
menu (see "Displaying settings").
Do not drink the liquids. Never use vinegar,
vinegar-based products, citric acid or citric
acid-based products for descaling. For
cleaning and descaling use only the tablets
included with the appliance. They were
specially developed for this fully automatic
espresso machine, and replacements are
available from retailers or customer service
(see "Accessories").
Never put descaling tablets or any other
descaling agents in the drawer for ground
coffee/cleaning tablets.
Important: If there is a filter in
the water tank (12), it needs to
be removed before the service
programme is run and should
only be replaced once the pro-
gramme is finished.
Never interrupt the service programme.
If one of the service programmes is
interrupted, e.g. by a power outage,
proceed as follows:
1. Rinse the water tank (12) and refill it
with fresh water up to the "max" mark.
2. Press start stop (8). The cleaning
programme will now run for about three
minutes.
Cleaning