Call Alert™ Operation; Introduction; Sending A Call Alert - Motorola GTX User Manual

INTRODUCTION

The Call Alert page feature enables your radio to function like a
pager (beeper). Your radio can receive and respond to pages from
other radios. Up to eight (8) mobile IDs (identified as CA1 through
CA8) can be programmed into the radio by your authorized
Motorola dealer.

SENDING A CALL ALERT

The Call Alert feature allows the dispatcher or supervisory unit to
alert or page up to eight mobile units.
1. To send a Call Alert page, press the
Call button twice. The display will
indicate:
2. Select a mobile ID from the ID list by pressing the Talkgroup
Select or
3. Press the PTT button to select and send the Call Alert.
•
The radio will beep once to indicate
that the Call Alert has been sent.
When the Call Aler t has been
acknowledged the display will indi-
cate:
•
The radio will sound four beeps and the display will automat-
ically return to the last selected trunked mode/talkgroup.
N OTE: If the radio is not in service or out of range, a low-pitched alert tone will
sound and the display will indicate "noS" . You may try this sequence
again when in range.
•
An illegal function tone will sound after six (6) seconds of
inactivity. This is to alert you that important channel activity
may be missed if you remain in Call Alert. Press the
Call button to stop the tone.
4. To exit Call Alert, press the
Call Alert™ Operation
buttons.
Home button.
Hm
15