AEG HSM/R 5614 Instruction Manual page 6

7 Cleaning brush
8 Power adapter
9 Charging station/stand
Table: Cutting step versus cutting length
Cutting step Cutting length
1= approx. 5 mm
2= approx. 8 mm
3= approx. 11 mm
4= approx. 14 mm
5= approx. 17 mm
6= approx. 20 mm
7= approx. 23 mm
Charging the Unit
• Turn the unit off. "OFF" can be seen on the switch.
• Connect the power adaptor connector with one of the following jacks.
• The socket directly at the bottom end of the unit.
• Alternatively place the unit in the charging station. The socket is at the rear.
• Plug the power adaptor into a 230 V/50 Hz wall outlet.
• The indicator light remains red during the charging process.
NOTE:
The charge indicator does not indicate the state of charge of the rechargeable battery.
• Charge the unit before first use for 10 hours.
NOTE:
• After initial use, do not charge the battery for longer than 8 hours at one time.
• If the battery is empty, the appliance can be operated from the mains. To do so, con-
nect the adapter directly to the clipper.
CAUTION:
After 8 hours always disconnect from mains power supply.
English
43