Download  Print this page

Advertisement

If you are using ...
6-wire
6-wire (Hexad Mode)
these leads can be selected at the
MX40 and the Information Center
I, II, III, aVR, aVL, aVF, V1, V2, V3, V4, V5, V6,
V7, V8, V9, V3R, V4R, V5R.
Sourced (raw) waves are received as:
Channel 1 = II
Channel 2 = III
Channel 3 = Va
Channel 4 = Vb
Factory Defaults are II, Va = V2, III, Vb = V5.
The two chest leads, Va and Vb, can be placed
on the patient in any of the V lead positions (V1
through V9, V3R, V4R, V5R). Lead assignment
is available at the Information Center. When
unassigned, the chest leads use the defaults.
The lead label assigned to Vb cannot
Note—
be selected for Va even though Vb does not
appear to be used.
When display of the pleth wave is enabled at the
Information Center, the second chest lead (Vb)
is not available for monitoring.
I, II, III, MCL, aVR, aVL, aVF, V1-V6.
Factory Defaults = Off, V1/V3, V1/V4, V1/V5,
V2/V4, V2/V5, V3/V5, V3/V6
Derived leads are labeled, e.g. dV3.
ECG and Arrhythmia Monitoring
ECG Leads Monitored
6-17

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: