Download  Print this page

Advertisement

Setting
ECG
New Lead Setup
Va Lead
Vb Lead
Change Numeric

Waveform Settings at the MX40

Setting
Wave 1
Wave 2
Primary or secondary waveform configuration changes made at the
Information Center change the MX40.
Description
Set ECG On/Off
When IntelliVue Patient Monitor lead sets are in
use, select 3-wire, or 5-wire.
Shows position of Va, or C1, electrodes. Choices
are V1-V9, v3R, V4R, V5R.
Shows position of Vb, or C2, electrodes. Choices
are V1-V9, v3R, V4R, V5R.
Selects parameter numeric to display in place of
current HR numeric.
Description
Primary, Secondary, I, II, III, aVR, aVL, aVF,
V1-V9, MCL, V3R, V4R, V5R. Available
waveforms are based on patient cable type. Lead
II is the default. If Primary or Secondary are
selected, then the waveform displayed is the
waveform configured as primary or secondary for
arrhythmia analysis.
Primary, Secondary, I,II, III, aVR, aVL, aVF,
V1-V9, MCL, V3R, V4R, V5R, Pleth (if SpO
available), Resp (if Resp is available). Available
waveforms are based on patient cable type. Lead
V is the default. If Primary or Secondary are
selected, then the waveform displayed is the
waveform configured as primary or secondary for
arrhythmia analysis.
Understanding Settings
is
2
Basic Operation
4-13

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: