Download  Print this page

Battery Status On The Charging Station Display; Battery Lifetime Management - Philips IntelliVue MX40 Instructions For Use Manual

Hide thumbs

Advertisement

If a battery is put on a charging station slot, the corresponding LED will
flash yellow until the battery's current state has been identified. Then a
beep is issued and the LED reflects the battery status as described in the
table below.
Status
no battery on charger slot
battery put on charger slot
battery not properly recognized, error
battery recognized, battery charging
battery recognized, battery full (>90%)
The AC Power / Error LED is
green when the charging station is connected to AC power
cyan during startup or to indicate a general charging station error
Note — Wiping of battery contacts with an alcohol solution after cleaning is
recommended.

Battery Status on the Charging Station Display

The IntelliVue CL Charging Station display provides a quick overview of
all the connected devices and their battery status. The screen is arranged in
the same layout as the charger slots.

Battery Lifetime Management

The lifetime of a li-ion battery depends on the frequency and duration of
use. When properly cared for, the useful life is approximately 4 years or 500
complete charge-discharge cycles, whichever comes first. In addition,
experience indicates that the incidence of failure may increase with battery
service life due to the accumulated stresses of daily use. We therefore
strongly recommend that li-ion batteries be replaced after 2 years or 500
complete charge-discharge cycles.
Charging Lithium-ion Rechargeable Batteries
LED
off
flashing yellow
cyan
yellow
green
Maintenance
14-9

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: