Download  Print this page

Label Assignment For Replacement Mx40; Re-assigning An Equipment Label At The Intellivue Information Center14-6 - Philips IntelliVue MX40 Instructions For Use Manual

Hide thumbs

Advertisement

Label Assignment for Replacement MX40

Label Assignment for Replacement MX40
Re-assigning an Equipment Label at the IntelliVue
Information Center
 To re-assign an equipment label to a replacement
14-6
Maintenance
During installation, an equipment label is assigned to each MX40 in a
clinical unit so that the device can be identified during operation within the
wireless system. If an MX40 is lost, the Assign Label function at the
Information Center enables you to unassign the label from a lost device,
and re-assign its label to a replacement device. Labels are limited to those
available in an individual clinical unit.
device:
1
At the Information Center, clear the sector that the original equipment
label was assigned to (Patient Window -> Sector Setup -> Clear
Sector -> OK).
Note — Before clearing the sector, ensure that the equipment label of
the lost device is not actively assigned to a patient being monitored.
2
Select All Controls -> Label Assignment.
3
Enter password.
Note — The remaining screens will be in English only.
4
Insert battery power into the MX40 and if attached, disconnect the
patient cable.
5
Select Refresh.
6
Select the MAC address of the replacement device from the New
Devices list. If the address does not appear, remove battery power and
re-insert. Select Refresh.
Note — The MAC address appears on the rear label of the MX40.
7
Select the equipment label that was assigned to the previous device
from the Equipment Label list.
8
Select Assign Label to initiate programming of the equipment label
into the replacement MX40.
9
When prompted, press Confirm on the MX40 to accept the assignment.
The confirmation must occur within 30 seconds of the prompt.

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: