Download  Print this page

Assigning Devices; Device Assignment At The Information Center; Device Assignment At The Mx40 - Philips IntelliVue MX40 Instructions For Use Manual

Hide thumbs

Advertisement

Assigning Devices

Device Assignment at the Information Center

You can assign an MX40 to a patient monitor at the Information Center. The
data from the MX40 automatically displays as a permanent overview
session in the Telemetry Data window on the patient monitor.
At the Information Center the MX40 data and the patient monitor data are
integrated in the patient sector.
Warning
All data presented in the Telemetry Data window are delayed for several
seconds. If you need realtime data, e.g. for defibrillation, always use the
ECG from the patient monitor.

Device Assignment at the MX40

 To assign an MX40 to an IntelliVue Cableless
Measurement device:
1
Press the SmartKey button.
2
Press the Add/Remove SmartKey.
3
From the Add to menu, select the desired device and press Confirm.
The MX40 will attempt to complete the assignment for a 2-minute period. If
assignment fails or the MX40 is no longer in range of the other device, the
short-range radio turns off to save battery power. Repeat the procedure
above to retry or resume the assignment. You may also need to restart the
short-range radio at the cableless measurement device if it has entered its
power save mode. Touch and hold the left button on the device to restart
the short-range radio.
 To assign an MX40 to an IntelliVue Patient Monitor:
1
Press the SmartKey button.
2
Press the Add/Remove SmartKey. The measurement selection key on
the monitor will change to show the "add cableless" icon
3
In the Add Cableless menu, select the correct equipment label for the
device.
Monitoring with other Assigned Devices
Assigning Devices
.
10-3

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: