Download  Print this page

Applying The Sensor; Connecting Spo Cables; Tone Modulation Indication; Signal Quality Indicator - Philips IntelliVue MX40 Instructions For Use Manual

Hide thumbs

Advertisement

Pulse Oximetry Measurement

Applying the Sensor

Connecting SpO

Tone Modulation Indication

Signal Quality Indicator

9-8
SpO2 Monitoring
Ambient Temperature: Never apply an SpO
temperatures above 37
after prolonged application.
Extremities to Avoid: Avoid sites distal to NBP cuff, intra-arterial line,
or intravascular venous infusion line.
1
Follow the SpO
sensor's Instructions for Use, adhering to all warnings
2
and cautions.
2
If necessary, remove colored nail polish from the application site.
3
Apply the sensor to the patient. The application site should match the
sensor size so that the sensor can neither fall off, nor apply excessive
pressure.
4
Check that the light emitter and the photodetector are directly opposite
each other. All light from the emitter must pass through the patient's
tissue.
Cables
2
The sensor cable is either directly connected to the blue SpO
the MX40 patient cable or is connected to an adapter cable that is then
connected to the MX40 SpO
The pulse signal tone is controlled by the setting in the SpO
Modulation menu.
Note — Tone Modulation Indication is only available when operating in
Continuous mode. It is not available when operating in Manual or Auto
mode.
The SpO
numeric is displayed together with a signal quality indicator
2
which gives an indication of the reliability of the current values.
The level to which the triangle is filled shows the quality of the signal. The
signal quality is at a maximum when the triangle is completely filled.
2
o
o
C (99
F) because this can cause severe burns
connector.
2
sensor at ambient
connector on
2
Tone
2

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: