Download  Print this page

Single Lead Analysis; Multilead Analysis; Multilead Analysis With Changes In One Lead - Philips IntelliVue MX40 Instructions For Use Manual

Hide thumbs

Advertisement

Alarm timeout periods are cleared.
Stored arrhythmia templates are cleared.
Asystole, Vfib, and HR alarms (when there are enough beats to
compute the HR) are active.
All other alarms are not active.

Single Lead Analysis

If single lead analysis is selected, the arrhythmia system begins learning
whenever:
ECG monitoring is initiated.
The Relearn Arrhy control is activated. See Initiating Arrhythmia
Relearning Manually p. 6-36.
The ECG Lead or Lead Label is changed manually, or when Fallback
occurs. See Fallback.
A "LEADS OFF" INOP condition (that has been active for >60 seconds)
ends.
When the MX40 re-associates with the Information Center.

Multilead Analysis

If multilead analysis is selected, the arrhythmia system begins a learning on
both leads whenever:
ECG monitoring is initiated.
The Relearn Arrhy control is activated (see Initiating Arrhythmia
Relearning Manually p. 6-36).
There has been a Leads Off INOP condition (that has been active for >60
seconds) for both leads, and the condition ends in either lead.
When the MX40 re-associates with the Information Center.

Multilead Analysis With Changes in One Lead

Since the arrhythmia system uses more than one lead for analysis, if there is
a change in one lead, the system does a relearn only on the affected lead.
This happens whenever:
An ECG lead or label is changed.
A Leads Off INOP condition (that has been active for >60 seconds) ends.
ST/AR Arrhythmia Monitoring
ECG and Arrhythmia Monitoring
6-35

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: