Inc. be liable to you for any incidental or consequential damages arising out of the use or inability to use the Product, even if Polk Audio, Inc. or a Polk Audio Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other party.
DVD player, push the “DVD” button on the top row. The Digital Solution preamp/processor will switch to the DVD input (if it is on) and the buttons on the DR-3 remote will be set to operate the DP-1 CD/DVD player.
Page 4
18.Tune+/SET-UP – Acts as the manual “tune up the dial” control for the radio of the Digital Solution system and calls up the Setup menu of a DVD player. For the function on other devices see the chart on page 6.
Page 5
29.SOURCE POWER – This button acts as the on/off button for the other components in your system once you have entered their remote codes into the DR-3. See pages 7 - 11 to learn how to pro- gram the DR-3 to operate other devices.
SAVE SAVE SAVE CNCL CNCL CNCL LEARN LEARN LEARN SYSTEM POWER POWER POWER SOURCE POWER POWER MACRO MACRO MACRO DR-3 FUNCTION LIST DVD/6CH CBL/CBL DIG Others LIGHT LIGHT LIGHT LIGHT MUTE MUTE MUTE MUTE MODE MODE MODE MODE VOL UP...
When you enter in the code the DR-3 “learns” most or all of the remote functions of that equipment so you don’t need to program the DR-3 button by button. There are tables on pages 14 - 15 that list the major audio/video brands and their three-digit remote codes.
PROGRAMMING THE REMOTE Auto Search Method If none of the three-digit code numbers assigned to your brand shut off your equipment or if your brand of equipment is not listed in the code tables, you can use the Auto Search Method to find the correct three- digit number for your equipment.
Source/Device button and then continue the instructions below to teach the new command to the MENU button. 3. Press the button on the DR-3 that is to be taught the new com- mand. The orange status light will begin to flash continuously.
PROGRAMMING THE REMOTE Erasing a Learned Command From a Button NOTE: You have 20 seconds to perform each step. If the source button light goes off, you need to back up a step and do it again. You can exit by pressing the CNCL (cancel) button at any time in the process.
Restoring Factory Programming If you want to restore the DR-3 to it’s original programming and oper- ation, press the LIGHT and POWER buttons simultaneously for 10 seconds. The red status light will blink while the remote is resetting.
DR-3 remote. Use any of the methods described earlier in this manual to fully program the DR-3 remote. It is a good idea to use your DR-3 remote for a few days to familiarize yourself with its basic operation before setting up MACRO operations.
Solution system’s input is on. Factory Reset If you want to restore the DR-3 to it’s original programming and operation, press the LIGHT and POWER buttons simultaneously for 10 seconds. The red status light will blink while the remote is resetting.
Need help?
Do you have a question about the DR-3 and is the answer not in the manual?
Questions and answers