CHAPTER 25 ELECTRICAL SPECIFICATIONS (STANDARD PRODUCTS, (A) GRADE PRODUCTS)
Notes 1.
Must be 6.5 V or lower.
2.
Make sure that the following conditions of the V
memory is written.
• When supply voltage rises
V
must exceed V
PP
voltage range (see a in the figure below).
• When supply voltage drops
V
must be lowered 10
DD
voltage range of V
2.7 V
V
DD
0 V
V
PP
2.7 V
0 V
Caution Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any
parameter. That is, the absolute maximum ratings are rated values at which the product is on the
verge of suffering physical damage, and therefore the product must be used under conditions that
ensure that the absolute maximum ratings are not exceeded.
Remark Unless specified otherwise, the characteristics of alternate-function pins are the same as those of port pins.
µ
10
s or more after V
DD
DD
µ
s or more after V
PP
(see b in the figure below).
DD
a
User's Manual U16227EJ2V0UD
voltage application timing are satisfied when the flash
PP
has reached the lower-limit value (2.7 V) of the operating
falls below the lower-limit value (2.7 V) of the operating
b
409