below.
SSP9210‐SM & SAX8210‐P
To pair SAX8210‐P with SSP9210‐SM, please follow steps below.
The first time pairing to DECT base
SAX8210‐P with factory default shows "NO SUB" after booting up.
To enable DECT base, SSP9210‐SM open a channel, please press *112*811# on the key
1.
pad. Then it will free all endpoints and be ready for pairing.
On the DECT base LCD display, it shows "DECT... Free Endpoints".
2. Press "*" button on the handset, SAX8210‐P will guide you into phone menu.
3. Select "2.Subscribe", then the handset starts searching DECT base.
4. It shows RFPI number on the display once it found an open DECT base.
Check RFPI number at the back of the DECT base. If it matches, then you are pairing the
handset to the base.
If the RFPI number is the one that the handset is pairing with, please press "LINE 1" to
5.
connect.
If the RFPI number is not the one you want to pair with, please press "#" button on the handset. Then it
will search another open DECT base in the air.
6. The handset shows Room Number once it is paired to the base.
Re‐pairing to DECT base
If it is required to re‐pair SAX8210‐P to another base, please press **6863* on the handset.
Then the handset will reset to factory default and reboot. It shows "NO SUB" on the display
after it boots up. Then please refer to "The first time pairing to DECT base" steps.
SGR8210‐SMK (BASE) & SGR8210‐SMK (HANDSET)
To pair SGR8210‐SMK (HANDSET) with SSP9210‐SM, please follow steps below.
The first time pairing to DECT base
SGR8210‐SMK (HANDSET) with factory default shows "NO SUB" after booting up. To pair with
SGR8210‐SMK (BASE), please put the SGR8210‐SMK (HANDSET) back to the base of
SGR8210‐SMK (BASE). After the handset put back to the base, it will automatically pair after
30 seconds.
Re‐pairing to DECT base
1
To match RFPI number between SSP9210‐SM and SAX9210‐P, please check if last 9 digits of SSP9210‐SM RFPI
number is same as first 9 digits showing on SAX9210‐P display.
1
8