Siemens SINAMICS V90 Operating Manual page 58

Task navigation
Setting the position setpoint in IPos control mode
In IPos control mode, you must specify the position setpoint on the following panel:
Linear axis or modular axis can be used depending on your actual application.
● The linear axis has a restricted traversing range and it is the factory setting of the
SINAMICS V90 servo drive.
● The modular axis has an unrestricted traversing range.
You can directly enter the digital value in the cells for the following items:
● Position
● Speed
● Acceleration
● Deceleration
The current active position setpoint channel is displayed at the bottom of this panel. The
channels correspond with p2617 and p2618 as follows:
Position setpoint channel
0
1
2
3
4
5
6
7
58
Index of p2617
0
1
2
3
4
5
6
7
Index of p2618
0
1
2
3
4
5
6
7
SINAMICS V-ASSISTANT Online Help
Operating Manual, 04/2017, A5E36618042-003