Siemens SINAMICS V90 Operating Manual page 141

Hide thumbs Also See for SINAMICS V90:
Table of Contents

Advertisement

7.
8.
SINAMICS V-ASSISTANT Online Help
Operating Manual, 04/2017, A5E36618042-003
Configure the PLC parameters.
Note:
Keep the PLC baud rate the same as the drive setting.
Set even parity check for the PLC (parity = 2).
Set a way for PLC sending message to slaves. Here we use the unicast mode and we
only want to send the message to slave 1.
Note:
If you want to send the message to all slaves, you need to set the slave address to 0
to use the broadcast mode.
Task navigation
141

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents