Timer Operation - Hitachi H8/3637 Hardware Manual

H8/3637 series
Table of Contents

Advertisement

Figure 9.8 shows a typical timing diagram for the noise canceller circuit. In this example, a high-
level input at the input capture pin is rejected as noise because its pulse width is less than five
sampling clock ø cycles.
Input capture
input signal
Sampling
clock
Noise canceller
output
9.4.4

Timer Operation

Timer G Functions: Timer G is an 8-bit up-counter that functions as an input capture timer or an
interval timer. These two functions are described below.
• Input capture timer operation
Timer G functions as an input capture timer when bit TMIG of port mode register 1 (PMR1) is
set to 1.*
At reset, timer mode register G (TMG), timer counter G (TCG), input capture register GF
(ICRGF), and input capture register GR (ICRGR) are all initialized to H'00.
Immediately after reset, TCG begins counting an internal clock with a frequency of ø divided
by 64 (ø/64). The clock to be input can be selected by using bits CKS1 and CKS0 in TMG
from four internal clock sources.
At the rising edge/falling edge of the input capture signal input to pin TMIG, the value of TCG
is copied into ICRGR/ICRGF. If the input edge is the same as the edge selected by the IIEGS
bit of TMG, then bit IRRTG is set to 1 in IRR2. If bit IENTG is also set to 1 in IENR2, a CPU
interrupt is requested. For details on interrupts, see 3.3, Interrupts.
TCG can be cleared to 0 at the rising edge, falling edge, or both edges of the input capture
signal as determined with bits CCLR1 and CCLR0 of TMG. If TCG overflows while the input
capture signal is high, bit OVFH of TMG is set. If TCG overflows while the input capture
signal is low, bit OVFL of TMG is set. When either of these bits is set, if bit OVIE of TMG is
currently set to 1, then bit IRRTG is set to 1 in IRR2. If bit IENTG is also set to 1 in IENR2,
then timer G requests a CPU interrupt. For further details see 3.3, Interrupts.
188
Rejected as noise
Figure 9.8 Noise Canceller Circuit Timing (Example)

Advertisement

Table of Contents
loading

This manual is also suitable for:

H8/3635H8/3636

Table of Contents