Table of Contents
Advertisement
Menu Operation
>
Use [LEFT] or [RIGHT] button to select
a zone number (AREA1 to AREA4) on the
[ZONE NUMBER].
>
Use [LEFT] or [RIGHT] button to set up the
ON or OFF on the ZONE STATE.
>
Use [UP] or [DOWN] to select an option
then use [LEFT] or [RIGHT] button to adjust
the option.
-
HEIGHT: Enlarge or decrease the vertical
size of the mask.
-
WIDTH: Enlarge or decrease the hori-
zontal size of the mask.
-
MOVE Y: Moves vertical position of the
mask.
-
MOVE X: Moves horizontal position of
the mask.
•
TAMPERING MD : You can detect that the camera
is polluted or damaged by spray or dust.
3.
Use [SENSITIVITY] option to obtain the optimum
detection level. (0 to 100)
32
3D-DNR Setting
1.
Select [3D-DNR] option.
If pictures are not clear due to brightness, this option
would reduce the noise of picture.
2.
Use [LEFT] or [RIGHT] button to select a option.
y
y
(OFF
LOW
MIDDLE
Notes:
•
If you set the AGC to [OFF] on the [EXPOSURE] menu,
the [3D-DNR] function is not available and [---] mark
is displayed.
•
When you use this function, the afterimage may occur.
y
HIGH)
Advertisement
Table of Contents
