PERIODIC MAINTENANCE AND ADJUSTMENT
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw, and then
turning the lens counterclockwise.
1
2
1. Turn signal light lens
2. Screw
7
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by turning it clock-
wise, and then installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
EAU38383
License plate light
If the license plate light does not come
on, have a Yamaha dealer check the
electrical circuit or replace the bulb.
[ECA11192]
EAU24331
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb
burns out, replace it as follows.
1. Remove the headlight unit. (See
2. Remove the auxiliary light bulb
1. Auxiliary light bulb socket
3. Remove the burnt-out bulb by
7-30
page 7-27.)
socket (together with the coupler)
by turning the socket counter-
clockwise.
pulling it out.
EAU40764