Table of Contents
Advertisement
8Intended use
Read these instructions carefully. You will only
I n t e n d e d u s e
be able to use your appliance safely and
effectively when you have read them. These
operating and installation instructions should
be retained, and passed onto the buyer if the
appliance is sold.
The manufacturer is exempt from all
responsibility if the requirements of this
manual are not complied with.
The images shown in these instructions are for
guidance only.
Do not remove the appliance from its
protective packaging until it is installed in the
unit. Do not switch on the appliance if it is
damaged in any way. Contact our Technical
Assistance Service.
Before installing your new hob, ensure that it is
being installed according to the assembly
instructions.
This appliance is not suitable for use in a
marine craft, caravan or mobile home.
This appliance must only be used in well
ventilated places. It must not be connected to
a combustion product removal device.
This appliance is not intended for operation
with an external clock timer or a remote
control.
This appliance has been designed for home
use only, not for commercial or professional
use. This appliance is only intended for
cooking purposes, not as a heating system.
The warranty will only be valid if the appliance
is used for the purpose for which it was
designed.
This appliance is intended for use up to a
maximum height of 2000 metres above sea
level.
Never leave the appliance unattended during
operation.
Do not use lids or protective barriers for
children which are not recommended by the
hob manufacturer. They may cause accidents
such as those due to the overheating, ignition
or detachment of fragments of materials.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance by
a person responsible for their safety. Children
should be supervised to ensure that they do
not play with the appliance.
All operations relating to installation,
connection, regulation and conversion to
other gas types must be performed by an
authorised technician, respecting all
applicable regulations, standards and the
specifications of the local gas and electricity
suppliers. Special attention shall be paid to
ventilation regulations.
This appliance leaves the factory set to the
gas type that is indicated on the specifications
plate. If this needs to be changed, please
consult the assembly instructions. It is
recommended you contact the Technical
Assistance Service to change to another gas
type.
Before installing, you need to check that local
distribution conditions are compatible with the
appliance's adjustment indicated on the
specifications plate (gas type and pressure,
power, voltage).
Before you begin, turn off the appliance's
electricity and gas supply.
The supply cable must be attached to the unit
to prevent it from touching hot parts of the
oven or hob.
Appliances with electrical supply must be
earthed.
Cabinets installed above the gas cooktop
must have a minimum clearance of 650 mm
(24").
The gas pressure regulator supplied with the
appliance must be installed in line with the gas
pipe. (N.G. only).
For pressure testing in excess of 3.5 kPa (1/
2 psig) the appliance and its individual shutoff
valve must be disconnected from the gas
supply piping system.
Important. When using a very large pot, leave
a gap of at least 50 mm (2") to avoid
damaging any parts in bench top wood,
plastic or other non-heat resistant materials.
Never leave oil or hot fat unattended.
Intended use
en
3
Advertisement
Table of Contents
