Accessories; Gas Burners; Switching On Manually; Automatic Ignition - Siemens EC9A5RB90A User Instructions

90 cm gas cooktop
Hide thumbs Also See for EC9A5RB90A:
Table of Contents

Advertisement

Gas burners

en
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Elements
1
Ignition plug
2
Thermocouple
3
Burner cup
4
Burner cap

Accessories

Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
Additional wok grid
Only suitable for use on wok
burners. Use cookware with a
rounded base.
Additional espresso maker
grid
Only suitable for use on the
smallest burner. Use cookware
with a diameter of less than
12 cm.
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.
Simmer cap
Burner cap that is used only
when cooking at minimum out-
put. The simmer cap must be
placed on the cover for the
economy burner.
--------
Code
HZ233540 Additional wok grid: Cast iron (4-5 kW)
HZ233440 Additional wok grid: Cast iron (mini wok
burner)
HZ241110 Additional espresso maker grid
HZ298105 Simmer Plate
HZ211310 Simmer cap
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
ÄGas burners

Switching on manually

G a s b u r n e r s
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power setting.
Hold an igniter or a naked flame (such as a lighter or
2.
a match) against the burner.

Automatic ignition

If your appliance has automatic ignition (ignition plugs):
Press the control knob for the selected burner and
1.
turn it anticlockwise to the highest power setting.
Sparks are produced on all burners while you are
pressing and holding the control knob. The burner
ignites.
Release the control knob.
2.
Turn the control knob to the required position.
3.
If the burner does not ignite, switch it off and repeat the
steps described above. This time, hold the control knob
down for longer (up to 10 seconds).
Page 10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ec9a5sb90a

Table of Contents