Black Box Abeo Manual And Installation Manual page 5

2.2 Unpack and inspect the equipment.
The carton should contain a single Black Box MTU9XXX model and a power cable. If there is
any visible damage, do not attempt to connect the device. Contact us for advice and
assistance. The rear panels of typical MTU9XXX units are shown on the previous page. Note
that the current rating shown on the rear panel label is the maximum current, which
corresponds to the lowest input voltage.
2.3 Optional rackmounting procedure
A Rackmounting kit may be used to mount two MTU9XXX units side by side in a 19" rack.
First remove the two rear panel screws securing each unit's lid. Fasten the two MTU9XXX
units to the rack mount adaptor plate using the screws that you have removed, as
shown in the illustrations below.
Then secure the rack mounting plate complete with the two MTU9XXX units to the 19" rack
using the locating holes at the ends of the adaptor plate. The recessed twin unit rack will
accept either AC or DC MTU9XXX models.
If you wish to use the optional 18 unit mounting rack, instructions are provided with the
rack.
Abeo/Opticon Fibre Converters
5