Socket Adapter Pin Correspondence Diagram - Hitachi H8/3664 Hardware Manual

In programmer mode, set the mode pins to programmer mode (see table 7.11) and input a 10 MHz
input clock. Use a PROM programmer that supports the Hitachi 64-kbyte on-chip flash memory
microcomputer device type (FZTAT64V5).
Table 7.11 shows the pin settings for programmer mode. For the pin names in programmer mode,
see section 1.4, Pin Functions.
Table 7.11 PROM Mode Pin Settings
Pin Names
Mode pins: TEST
Mode setting pins: PB2, PB1, PB0
RES pin
OSC2, OSC1
7.10.1

Socket Adapter Pin Correspondence Diagram

Connect the socket adapter to the chip as shown in figure 7.12. This will enable conversion to a
32-pin arrangement. The on-chip ROM memory map is shown in figure 7.12, and the socket
adapter pin correspondence diagram in figure 7.13.
Addresses in
user mode
H'0000
On-chip ROM space
32 kbytes
H'7FFF
Figure 7.12 On-Chip ROM Memory Map
Settings
High level input to TEST
Low level input to PB2, PB1, and PB0
Power-on reset circuit
Oscillator circuit
Addresses in
programmer mode
H'0000
H'7FFF
123