Camber And Caster; Rear Spring - Polaris Sportsman S Owner's Manual

ADJUSTMENTS

Camber and Caster

The camber and caster are non-adjustable.

Rear Spring

The rear shock absorber spring is
adjusted by rotating the adjuster (1)
either clockwise or
counterclockwise to increase or
decrease spring tension.
NOTE: Accessory springs are
available through your Polaris
dealer.
Handlebars
Improper adjustment of the handlebars or incorrect torquing of
the adjuster block tightening bolts can cause limited steering or
loosening of the handlebars, resulting in loss of control and
possible serious personal injury or death. Follow the adjustment
procedures exactly, or see your Polaris dealer for service.
The handlebars can be adjusted for
rider preference.
1. Locate handlebar bolts (1) by
removing the upper headlight pod.
2. Loosen the four bolts.
3. Adjust the handlebar to the desired
height. Be sure the handlebars do not
contact the gas tank or any other part of
the machine when turned fully to the left or right.
4. Torque the front two bolts to 10-12 ft. lbs. (14-17 Nm), then torque
the rear two bolts. A gap of up to 1/8" will remain at the rear bolts.
114
WARNING
1
1