Driving Through Water - Polaris Sportsman 9922237 Owner's Manual

Driving Through Water

Your ATV can operate
through water with a
maximum recommended
depth equal to the bottom of
the footrests. Follow these
procedures when operating
through water:
1. Determine water depths
and current before
entering water.
2. Choose a crossing
where both banks have
gradual inclines.
3. Avoid operating through deep or fast-flowing water.
NOTICE: Major engine damage can result if the vehicle is not thoroughly
inspected after operation in water. Perform the services outlined in
the maintenance chart. See page 67. The following areas need
special attention: engine oil, transmission oil, demand drive fluid and
all grease fittings
If the vehicle tips or overturns in water, or if the engine stops during or
after operating in water, restarting can result in serious engine
damage. Transport the vehicle to your dealer for service before
restarting the engine. If this is not possible, follow the vehicle
immersion inspection and drying procedures outlined on page 102,
then see your dealer for service at the first opportunity.
4. After leaving water, test the brakes. Apply them lightly several
times while driving slowly. The friction will help dry out the pads.
If it's unavoidable to enter water deeper than the footrest level:
• Proceed slowly. Avoid rocks and obstacles.
• Balance your weight carefully. Avoid sudden movements.
• Maintain a steady rate of speed. Do not make sudden turns or stops.
Do not make sudden throttle changes.
Maximum Depth
.
OPERATION
59