Table 5 Pressure Screw Tightening - ABB A140-H55 Operation Manual

Operation Manual / 4 Product description / A130-H.. - A140-H..
2 Removing and Installing
Tightening pressure screws
Figure 14: Tightening pressure screws
Product
A140
Table 5: Pressure screw tightening torque
1. Screw in pressure screws crosswise by hand until reaching the stop.
2. Tighten pressure screws crosswise to 50 % of the tightening torque specified in the table.
3. Tighten pressure screws crosswise to 100 % of tightening torque specified in table.
4. Work in a circle to tighten all pressure screws to 100 % of the tightening torque specified in
the table.
5. Tighten pressure screws to 100 % in 5 ... 7 rounds until the required residual tightening
angle of < 20° is achieved.
© Copyright 2015 ABB. All rights reserved.
Torque-controlled tightening
Fixing screw [mm]
M24
HZTL4030_EN
Page 21 / 115
Tightening torques [Nm]
35
Revision C September 2015