Adjusting The Neck Cord - Philips lifeline AutoAlert Help Button FD100 User Manual

3. Continue checking all of the areas in and around your home. Be sure to check the bathroom,
basement and garage.
4. Press the Reset Button on the communicator to exit Signal Range Test mode. If you do not
press the Reset Button, the test will automatically end after 4 minutes.
5. At this point, any press of the AutoAlert Help Button should send a signal to the Lifeline
Response Center. Press your Help Button to send a test call to the Lifeline Response Center
and confirm that everything is working properly.
Caution: The signal range may be affected by environmental factors including building materials
(e.g., concrete, metal), large masses covering or obstructing the Help Button, or submersion in
liquid. Be sure to thoroughly test the coverage range of the Help Button in all areas of your
home including the bathroom, basement and garage.

Adjusting the Neck Cord

For assistance, call 1-800-635-6156 in the U.S. and 1-800-387-1215 in Canada.
To shorten: With a tab between your first finger and
thumb of each hand, slide both tabs apart in line with
your shoulders.
To lengthen: Pull one strand of the neck cord while
sliding the tab to the back. Repeat on the other side.
11