Error Messages/Display Messages
Message
Possible Causes
The number carriage
EXCESS LINES
returns you input causes
the label to exceed the
maximum number of
lines for the tape you are
using.
Data in memory has
INITIALIZE!
become corrupted for
some reason.
Battery power is low.
LOW BATTERY!
Ambient temperature is
below 10°C (50°F).
You are attempting to
NO DATA!
recall text from memory
when there is none
stored.
You are attempting to
OVERWRITE?
store text in memory
when it already contains
text.
Action
Use wider tape or reduce
the number of lines.
6mm tape...1 line
9mm tape...1 line
12mm tape...Up to 2 lines
18mm tape...Up to 2 lines
Press any key to initialize
the Label Printer.
Replace the batteries
with new ones or use the
specified AC adaptor.
Use the printer in a
location within the
operating temperature
range (10°C to 35°C;
50°F to 95°F).
Store the text in memory
and then try again.
Press OK to overwrite the
existing text with the new
text, or
to cancel the
store operation.
Message
Possible Causes
The tape became
PRINT ERROR!
jammed during printing.
This message appears
TAPE IS LONG
when the length of the
tape that will actually be
printed is longer than the
specified tape length.
Action
Turn off the printer
and remove the tape
cartridge. Next, remove
the jammed tape.
* If the steps described
above do not clear the
error message, contact
your retailer or your
nearest CASIO service
center.
To print, press OK.
To cancel printing,
press
. You can then
decrease the number of
characters or change to a
longer tape setting.
25
EN