Download  Print this page

Philips IntelliVue MX40 Instructions For Use Manual Page 98

Wearable patient monitor.
Hide thumbs

Advertisement

Single Lead Analysis
If single lead analysis is selected, the arrhythmia system begins alearning
whenever:
Multilead Analysis
If multilead analysis is selected, the arrhythmia system begins a learning on
both leads whenever:
Multilead Analysis With Changes in One Lead
Since the arrhythmia system uses more than one lead for analysis, if there is
a change in one lead, the system does a relearn only on the affected lead.
This happens whenever:
Note— During this learning phase the system will continue monitoring
using the operative lead. Therefore, the delayed arrhythmia wave is not
labeled"L". In addition:
5-30
ECG and Arrhythmia Monitoring
Asystole, Vfib, and HR alarms (when there are enough beats to
compute the HR) are active.
All other alarms are not active.
ECG monitoring is initiated.
The Relearn key is activated (see Initiating Arrhythmia Relearning
Manually p. 5-31).
The ECG Lead or Lead Label is changed manually, or when Fallback
occurs (see ECG Fallback p. 5-23).
A Leads Off INOP condition (that has been active for >60 seconds) ends.
ECG monitoring is initiated.
The Relearn key is activated (see Initiating Arrhythmia Relearning
Manually p. 5-31).
There has been a Leads Off INOP condition (that has been active for >60
seconds) for both leads, and the condition ends in either lead.
An ECG lead or label is changed.
A Leads Off INOP condition (that has been active for >60 seconds) ends.
Alarm timeout periods are maintained.
Stored arrhythmia templates are maintained for the operative lead.
All alarms turned on are active.

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

   Related Manuals for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: