Download  Print this page

Mx40 Controls In The Patient Window - Philips IntelliVue MX40 Instructions For Use Manual

Wearable patient monitor.
Hide thumbs

Advertisement

MX40 Controls in the Patient Window

The Patient Window at the Information Center (accessed from the Patient
Window control in the Patient Sector) includes controls for a number of
MX40 operations. For detailed instructions on these operations, see the
IntelliVue Information Center Instructions for Use or the Online Help.
 To View ECG or SpO
1
 To Change ECG or SpO
1
2
 To Change ECG Waveform Size
1
2
 To Select Lead
1
2
Important — Do not set the primary and secondary channels to the same
lead.
 To Change Va and Vb Default Lead Settings (6-lead
only)
1
2
3
9-2
Monitoring with the MX40 at the Information Center
Move the cursor over the HR or SpO
and low alarm limits.
Move the cursor over the High or Low numeric to display up/down
arrow controls for adjusting the limit.
After adjusting the limit, move the cursor away from the area to dismiss
the limit controls.
Move the cursor over the ECG waveform to display the ECG Waveform
Size control.
Select the desired size from the list.
Move the cursor over the ECG waveform to display the Lead Selection
control.
Select the desired lead from the list.
Move the cursor over the ECG waveform to display the Lead Selection
popup.
Select the label from the label list.
For Va or Vb, select Va or Vb, then select the lead to be assigned.
Assignment of the same V lead to both Va and Vb is not allowed.
Alarm Limits
2
label to display the current high
2
Alarm Limits
2

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: