Download  Print this page

Measuring Spo - Philips IntelliVue MX40 Instructions For Use Manual

Wearable patient monitor.
Hide thumbs

Advertisement

The level to which the triangle is filled shows the quality of the signal. The
signal quality is at a maximum when the triangle is completely filled.

Measuring SpO

Warning
Removal of the SpO
Continuous SpO
Silencing this alarm turns the SpO
module is still operating in the background and consuming battery
power. If you do not intend to resume continuous SpO
change to Manual mode.There is no technical alarm for a "No Sensor"
condition in Manual mode.
If you measure SpO
non-pulsatile SpO
configured to suppress this alarm, there can be a delay of up to 60
seconds in indicating critical patient status, such as sudden pulse loss or
hypoxia.
SpO
measurements can be made manually on an as-needed basis in
2
Manual mode, or continuously in Continuous mode, depending on your
MX40 configuration. While operating in Continuous mode, you can also
measure pulse, and display the pleth wave on the MX40 and at the
Information Center. The SpO
a control from the Information Center. SpO
considerable electrical energy. The battery power must be at least 10% full
in order to make SpO
To resume the SpO
blank measurement area and select SpO
Note — Before disabling SpO
active alarms at the MX40.
Setting the mode to Manual or Continuous can be done at the Information
Center or at the MX40.
 To select the measurement mode at the MX40:
1
In Spo
Setup, select Mode.
2
2
Select Continuous or Manual mode.
2
sensor from the MX40 patient cable during
2
monitoring results in a "No Sensor" technical alarm.
2
on a limb that has an inflated NBP cuff, a
2
technical alarm can occur. If the monitor is
2
parameter is turned on/off at the MX40 or by
2
measurements.
2
measurement after it has been turned off, touch the
2
at the Information Center, acknowledge any
2
measurement off, however the SpO
2
2
monitoring consumes
2
to turn it back on.
2
SpO2 Monitoring
2
monitoring,
7-9

Advertisement

Table of Contents

   Also See for Philips IntelliVue MX40

Comments to this Manuals

Symbols: 0
Latest comments: