Pitney Bowes DM475 Operator's Manual page 3

Servicing
This equipment is not intended to be serviced by the user. Please refer to the
warranty information if problems occur. The responsible party is Pitney Bowes
Canada, 5500 Explorer Drive, Mississauga, Ontario L4W 5C7. All service
and supply inquiries can be done by calling 1-800-672-6937 and following the
telephone prompts. Customer Service Representatives are available Monday
through Friday, 8:00 AM - 8:00 PM ET.
Industry Canada
This product meets the applicable Industry Canada technical specifications.
The Ringer Equivalence Number (REN) is an indication of the maximum
number of devices allowed to be connected to a telephone interface. The
Ringer Equivalence Number (REN) of this terminal equipment is 1.0 (with the
exception of the K7M0, which is 0.3). The termination on an interface may
consist of any combination of devices subject only to the requirement that
the sum of the RENs of all devices does not exceed five.
The abbreviation, IC, before the registration number signifies that registration
was performed based on a Declaration of Conformity indicating that Industry
Canada technical specifications were met. It does not imply that Industry
Canada approved the equipment.
Declaration of Conformity According to FCC Rules Part 2 ,
Paragraph 2.1077
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. Responsible party: Pitney Bowes Canada,
5500 Explorer Drive, Mississauga, Ontario L4W 5C7.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause interference
to radio communications. Operation of this equipment in a residential area is
likely to cause interference in which case the user will be required to correct
the interference at his own expense.
CAUTION: Changes or modifications to this equipment
not expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
Shielded I/O and USB cables must be used with this equipment to ensure
compliance with the limits. Use of unshielded cables is prohibited.