Catalytic Cooking Compartment Panels; Removing And Installing The Door Panels - Siemens HG10LG050M Instruction Manual

Area Cleaning agents
Door panels Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Glass cover for the Hot soapy water:
oven light Clean with a dish cloth.
Seal Hot soapy water:
Do not remove. Clean with a dish cloth. Do not scour.
Rails Hot soapy water:
Soak and clean with a dish cloth or
brush.
Accessories Hot soapy water:
Soak and clean with a dish cloth or
brush.

Catalytic cooking compartment panels

The catalytic cooking compartment panels are coated with self-
cleaning enamel.
The surfaces clean themselves while the oven is in operation.
Larger splashes will only be removed after the oven has been
used several times.
Self-cleaning surfaces
The side walls are covered with catalytic panelling. Never clean
these surfaces with oven cleaner. Slight discolouration of the
enamel does not affect automatic self-cleaning.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Removing the door panels
Open the oven door fully.
1.
Lock both hinges on the left and right using the locking pin.
2.
Note: The locking pins must be fully inserted into the holes in
the hinges.
Lift the bottom of the inner panel slightly until the fastening
3.
pins come out of the holder (1).
10
Carefully lift the top of the inner panel until the fastening pins
4.
come out of the holder (2).
Caution!
When lifting the inner panel, the middle panel may stick to the
inner panel. Make sure that the middle panel does not fall.
Remove the inner panel.
5.
Remove the middle panel.
6.
Note: The middle panel is kept in place with rubber bushings
rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.