Adjustable Sounds - Philips IntelliVue TRx Instructions For Use Manual

Audible Tones
Information
Sound 4
Sound 5
Sound 6
Sound 7
Adjustable
Some transceiver sounds can be set to 5 different volume levels (see "Patient
Sounds
Configurable Settings in Telemetry Setup" on page 9-6). The adjustable sounds
includeSpO
3-12 Transceiver Controls
Draft - 1 Aug 08
Auditory
Signal Sound
beep beep
beep beep
every 5 seconds
beep every 2
seconds
Fast beep beep
and all Leads
Off indicators
briefly flashing
at the same
time
Spot Check measurement complete/fail, Check/Standby functions,
2
How Used
• Indicates failed Self-Test at power on.
• Indicates failed SpO
measurement when measurement is
initiated at the transceiver.
• If it sounds when the Check button is
pressed, it indicates that the transceiver
is not in contact with the Information
Center, or in cases where the
transceiver is not assigned to a sector at
the Information Center but is assigned
to a monitor via short-range radio, the
transceiver is not in contact with the
monitor.
Indicates transceiver is out of range or not
associated with a sector. Sound stops when
contact is re-established with the Information
Center, or it can be silenced by pressing the
Check button for six seconds.
Indicates that the leadset is not inserted
correctly. Accompanied by Invalid Leadset
INOP.
A new assignment has been established
between the transceiver and monitor via
short-range radio connection.
Spot Check
2