Language; Auto-Scan In Osd: <F2; Start To Auto-Scan In Osd; Stop Auto-Scan - D-Link KVM-440 User Manual

8/16 port combo kvm switch
Hide thumbs Also See for KVM-440:
Table of Contents

Advertisement

7.3.7. Language

The 3 available languages are English (En) / Deutsch (De) / Français (Fr).
7.4. Auto-Scan in OSD: <F2>

7.4.1. Start to Auto-Scan in OSD

To start auto-scanning, press <F2> in the OSD main menu. The auto-scan
banner will appear, displaying the channel currently being scanned.
─┬──
└───────────────
Note: You can also start the auto-scan function via hotkey using
<Scroll Lock> → <Scroll Lock> → <S> → <Enter> outside of OSD
mode. Please refer to section 6.6.1 Start Auto-Scan Function.

7.4.2. Stop Auto-Scan

Press any key on the keyboard to STOP the auto-scan function. The
auto-scan banner will disappear when the scan stops.

7.4.3. Auto-Scan Mode

There are two auto-scan modes. Please refer to section 7.3.1 Setup in
OSD – Scan Mode to set up the auto-scan mode.
 Scan all active connected computers.
 Only scan computers which are marked for auto-scanning.

7.4.4. Auto-Scan Time Interval

The auto-scan time interval of each displayed port can be adjusted by
pressing <F1> in the OSD main menu. Please refer to section 7.3.2 Setup
in OSD – Scan Time.
──┬──────
└──────────
Figure 22: Auto-Scan Banner
25
└─
Channel Name
Channel Number
Indicates Scan Mode

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kvm-450

Table of Contents