Address Space - Siemens SIMATIC ET 200SP Manual

4.3

Address space

The module can be configured differently in STEP 7; see following table. Depending on the
configuration, additional/different addresses are assigned in the process image output/input.
Configuration options of DQ 4×24VDC/2A HF
You can configure the module with STEP 7 (TIA Portal) or with a GSD file. When you
configure the module by means of the GSD file, the configuration is available under different
abbreviations/module names. The following configurations are possible:
Table 4- 2 Configuration options with GSD file
Configuration
1 x 4-channel without value
status
1 x 4-channel with value status
1 x 4-channel with value status
for module-internal Shared
Output with up to 4 submodules
1 x 4-channel without value
status
1 x 4-channel with value status
1 x 4-channel with value status
for module-internal Shared
Output with up to 4 submodules
2 x 2-channel without value
status
2 x 2-channel with value status
Note
The following functions are only fully available when the submodule X.1 is configured and
the IO controller to which submodule X.1 is assigned has established a connection to the
IO device.
• Firmware update
• I&M identification data
• PROFIenergy
Digital output module DQ 4x24VDC/2A HF (6ES7132-6BF20-0CA0)
Manual, 12/2015, A5E32855695-AC
Abbreviation/module
name in the GSD file
DQ 4×24VDC/2A HF
V1.0
DQ 4×24VDC/2A HF
V1.0, QI
DQ 4×24VDC/2A HF
V1.0, MSO
DQ 4×24VDC/2A HF
V2.0
DQ 4×24VDC/2A HF
V2.0, QI
DQ 4×24VDC/2A HF V2.
0, MSO
DQ 4×24VDC/2A HF
V2.0, S.2
DQ 4×24VDC/2A HF
V2.0, S.2 QI
Configuration software, e.g. STEP 7 (TIA Portal)
Integrated in the
hardware catalog PROFINET IO
STEP 7, as of
V13, SP1
X
X
X
---
---
---
---
---
Parameters/address space
4.3 Address space
GSD file GSD file
PROFIBUS DP
X X
X ---
X ---
X ---
X X
X ---
X ---
X ---
17