Download  Print this page

Attaching The Front Panel; Adjusting The Angle Of The Front Panel - Sony CDX-GT980UI Operating Instructions Manual

Hide thumbs

Advertisement

Table of Contents
3
Slide the front panel to the left, then
gently pull out the front panel towards
you.
(OFF)
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.

Attaching the front panel

Place the hole A of the front panel onto the
spindle B on the unit, then lightly push the left
side in.
Press (SOURCE) on the unit (or insert a disc) to
operate the unit.
Note
Do not put anything on the inner surface of the front
panel.
A
B
Adjusting the angle of the front
panel
1
Press and hold (ANGLE).
"Angle Adjust" will appear in the display.
2
Press (ANGLE) repeatedly until the
front panel is angled accordingly.
The front panel can be set to 3 positions.
3
Press any button on the unit except
(ANGLE).
The display returns to normal reception
mode.
If no button is pressed for 30 seconds, the
display returns to normal reception mode.
Tips
• After the front panel slides down (to insert the disc),
it returns to the position you set again automatically.
• The front panel angle you set is stored in the unit.
When turning the ignition off, the angle returns to its
default position, then turning the ignition on, the front
panel is angled you set.
(ANGLE)
7

Advertisement

Chapters

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: