Download  Print this page

Radio; Storing And Receiving Stations; Storing Automatically - Btm; Storing Manually - Sony CDX-GT980UI Operating Instructions Manual

Hide thumbs

Advertisement

Table of Contents
1
Press (ZAP) during playback.
After "ZAPPIN" appears in the display,
playback starts from a passage of the next
track.
The passage is played for the set time, then a
click sounds and the next passage starts.
Track
1
1
2
2
ZAP
The part of each track to
playback in ZAPPIN mode.
2
Press the multi way encoder or (ZAP)
when a track you want to listen is
played back.
The track that you select returns to normal
play mode from the beginning.
To search a track by ZAPPIN mode again,
repeat steps 1 and 2.
Tips
• You can select the playback time from about 6
seconds/9 seconds/30 seconds (page 21).You
cannot select the passage of the track to playback.
• Push the multi way encoder left/right in ZAPPIN
mode to skip a track.
• Push the multi way encoder up/down in ZAPPIN
mode to skip album.
• Pressing
(BACK) also confirms a track to
playback.
3
3
4
4

Radio

Storing and receiving stations

Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press (SOURCE) repeatedly until
"TUNER" appears.
To change the band, press (MODE)
repeatedly. You can select from FM1, FM2,
FM3, AM1 or AM2.
2
Press and hold the multi way encoder.
3
Rotate the multi way encoder until
"BTM" appears, then press it.
The unit stores stations in order of frequency
in the preset list.
A beep sounds when the setting is stored.

Storing manually

1
While receiving the station that you
want to store, push
The preset list appears.
2
Rotate the multi way encoder to select
the preset number.
3
Push and hold the multi way encoder
until "MEM" appears.
(with the card remote commander)
1
While receiving the station that you
want to store, press and hold a
number button ((1) to (6)) until
"MEM" appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.

Receiving the stored stations

1
Select the band, then push the multi
way encoder up/down.
(with the card remote commander)
1
Select the band, then press a number
button ((1) to (6)).
(BROWSE).
13

Advertisement

Chapters

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: