Power Supply; Turning The Power On/Off - Yamaha genos Owner's Manual

Power Supply

1
Connect the supplied power cord to the [AC IN] jack on the
instrument's rear panel.
2
Connect the other end of the power cord to an AC outlet.

Turning the Power On/Off

1
Turn down the [MASTER VOLUME] dial to "MIN."
2
Press the [ ] (Standby/On) switch to turn the power on.
The Home display (page 30) appears. Adjust the volume as desired while playing
the keyboard.
2
3
After you finish using the instrument, turn off the power by
pressing and holding the [
second.
] (Standby/On) switch for about a
WARNING
Use only the supplied power cord.
CAUTION
When setting up the product,
make sure that the AC outlet you
are using is easily accessible. If
some trouble or malfunction
occurs, immediately turn off the
power switch and disconnect the
plug from the outlet.
NOTE
When disconnecting the power cord,
first turn off the power, then follow this
procedure in reverse order.
NOTE
Until the Home display appears, no
operations can be carried out, including
power-off and keyboard performance.
CAUTION
Even when the power switch is
turned off, electricity is still flow-
ing to the product at the minimum
level. When you are not using the
product for a long time, make
sure to unplug the power cord
from the wall AC outlet.
NOTICE
When recording or editing, or
while a message is displayed, the
power cannot be turned off even if
you press the [ ] (Standby/On)
switch. If you want to turn off the
power, press the [ ] (Standby/
On) switch only after recording,
editing, or after the message has
disappeared. If you need to force-
quit the instrument, hold down
the [ ] (Standby/On) switch for
longer than three seconds. Note
that the force-quit operation
might cause data loss and dam-
age to the instrument.
Genos Owner's Manual
23