Yamaha genos Owner's Manual page 122

Mixer
The sound seems strange or different than
expected when changing a rhythm Voice
(drum kit, etc.) of the Style or Song from the
Mixer.
Microphone/Vocal Harmony
The microphone input signal cannot be
recorded.
Harmony can be heard in addition to the
microphone sound.
The Vocal Harmony effect sounds distorted
or out-of-tune.
The Vocal Harmony effect is not applied
even when it is turned on.
ASSIGNABLE FOOT PEDAL jacks
The on/off setting of the footswitch con-
nected to the ASSIGNABLE FOOT PEDAL
jack is reversed.
AUX IN jacks
Sound input to the AUX IN jacks is inter-
rupted.
122
Genos Owner's Manual
When changing the rhythm/percussion Voices (drum kits, etc.) of the Style and Song
from the VOICE parameter, the detailed settings related to the drum voice are reset, and
in some cases you may be unable to restore the original sound. You can restore the orig-
inal sound by selecting the same Song or Style again.
The microphone input signal cannot be recorded by MIDI recording. Record by using
Audio recording (page 91).
Vocal Harmony is set to on. Turn Vocal Harmony off (page 85).
Your vocal microphone may be picking up extraneous sounds, such as the Style sound
from the instrument. In particular, bass sounds can cause mistracking of the Vocal Har-
mony. To remedy this:
• Sing as closely to the microphone as possible.
• Use a directional microphone.
• Turn down the Master volume, Style volume, or Song volume control (pages 23, 86).
• Separate the microphone from the external speakers as far as possible.
In the Chordal mode, Vocal Harmony is added only when chords are detected. Try one of
the following:
• Turn on the [ACMP ON/OFF] button and play chords in the chord section during Style
playback.
• Turn on the Left part and play chords in the left hand section.
• Play back a Song which contains chords.
• Set the "Stop ACMP" parameter to something other than "Disabled" via [MENU] 
[Style Setting]  [Setting]. For details, refer to the Reference Manual on the website.
Turn the instrument's power off, then turn it on again making sure not to press the foot-
switch.
The output volume of the external device connected to this instrument is too low.
Increase the output volume of the external device. The volume level reproduced via this
instrument can be adjusted by using the [MASTER VOLUME] dial.