Periodic Maintenance Procedures
Third Step
•
Set the dimmer switch [A] to high beam position.
•
The high beam headlights [B] should go on.
•
The blue high beam indicator light (LED) [C] should go on.
If the high beam headlight and/or blue high beam indicator
light (LED) does not go on, inspect or replace the following
parts.
Headlight Bulbs (see Headlight Bulb Replacement in the
Electrical System chapter)
High Beam Headlight Relay (see Relay Inspection in the
Electrical System chapter)
Dimmer Switch (see Switch Inspection in the Electrical
System chapter)
•
Turn the ignition switch off.
•
The headlights and blue high beam indicator light (LED)
should go off.
Headlight Aiming Inspection
The headlight beam is adjustable vertically.
•
Inspect the headlight beam for aiming.
If necessary, adjust the headlight beam.
•
Remove the front center cover (see Front Center Cover
Removal in the Frame chapter).
•
Adjust the headlight up or down by turning the adjuster.
Right Headlight Adjuster [A]
Left Headlight Adjuster [B]
○
On high beam, the brightest point [A] should be slightly
below horizontal with the motorcycle on its wheels and
the rider seated. Adjust the headlight to the proper an-
gle according to local regulations.
NOTE
PERIODIC MAINTENANCE 2-41
Comments to this Manuals
Latest comments: