Periodic Maintenance Procedures
•
Replace the fluid seals [A] and the dust seals [B] with new
ones.
○
Apply brake fluid to the seals, and install them into the
cylinders by hand.
•
Apply brake fluid to the outside of the pistons, and push
them into each cylinder by hand.
•
Check the friction boots [A] and replace them with new
ones if they are damaged.
•
Apply silicone grease to the caliper holder shafts [B].
•
Install the pad springs [A].
•
Install the pads (see Rear Brake Pad Installation in the
Brakes chapter).
•
Wipe up any spilled brake fluid on the caliper with wet
cloth.
Brake Pad Wear Inspection
•
Remove the brake pads (see Front/Rear Brake Pad Re-
moval in the Brakes chapter).
•
Check the lining thickness [A] of the pads in each caliper.
If the lining thickness of either pad is less than the service
limit [B], replace both pads in the caliper as a set.
Front Brake Pad [C]
Rear Brake Pad [D]
Pad Lining Thickness
Standard:
Front
Rear
Service Limit:
Front
Rear
5 mm (0.20 in.)
5.8 mm (0.23 in.)
1 mm (0.04 in.)
1 mm (0.04 in.)
PERIODIC MAINTENANCE 2-35
Comments to this Manuals
Latest comments: