Switches and Sensors
Fuel Level Sensor Inspection
Remove the fuel pump (see Fuel Pump Removal in the
Fuel System (DFI) chapter).
Connect a digital meter to the fuel pump connector.
Measure the fuel level sensor resistance.
Fuel Level Sensor Resistance
Y/W lead terminal [A] ← → BL/W lead terminal [B]
Full Position [C] 1100 ±33 Ω @20°C (68°F)
Empty Position [D] 100 ±3 Ω @20°C (68°F)
If the tester does not read as specified, replace the fuel
Speed Sensor Removal/Installation
Refer to the Front Rotation Sensor Removal/Installation
in the Brakes chapter.
Speed Sensor Inspection
Refer to the Wheel Rotation Sensor Inspection in the
Oxygen Sensor Removal
Remove the storage box (see Storage Box Removal in
the Frame chapter).
Disconnect the oxygen sensor lead connector [A].
Do not pull strongly, twist, or bend the oxygen sen-
sor lead. This may cause the wiring open.
Remove the oxygen sensor [A].
ELECTRICAL SYSTEM 16-65